Design of interface selection protocols for multi-homed wireless networks

Abstract

The IEEE 802.11/802.16 standards conformant wireless communication stations have multi-homing transmission capability. To achieve greater communication efficiency, multi-homing capable stations use handover mechanism to select appropriate transmission channel according to variations in the channel quality. This thesis presents three internal-linked handover schemes, (1) Interface Selection Protocol (ISP), belonging to Wireless Local Area Network (WLAN)- Worldwide Interoperability for Microwave Access (WiMAX) environment (2) Fast Channel Scanning (FCS) and (3) Traffic Manager (TM), (2) and (3) belonging to WiMAX Environment. The proposed schemes in this thesis use a novel mechanism of providing a reliable communication route. This solution is based on a cross-layer communication framework, where the interface selection module uses various network related parameters from Medium Access Control (MAC) sub-layer/Physical Layer (PHY) across the protocol suite for decision making at the Network layer. The proposed solutions are highly responsive when compared with existing multi-homed schemes; responsiveness is one of the key factors in the design of such protocols. Selected route under these schemes is based on the most up to date link-layer information. Therefore, such a route is not only reliable in terms of route optimization but it also fulfils the application demands in terms of throughput and delay. Design of ISP protocol use probing frames during the route discovery process. The 802.11 mandates the use of different rates for data transmission frames. The ISP-metric can be incorporated into various routing aspects and its applicability is determined by the possibility of provision of MAC dependent parameters that are used to determine the best path metric values. In many cases, higher device density, interference and mobility cause variable medium access delays. It causes creation of ‘unreachable zones’, where destination is marked as unreachable. However, by use of the best path metric, the destination has been made reachable, anytime and anywhere, because of the intelligent use of the probing frames and interface selection algorithm implemented. The IEEE 802.16e introduces several MAC level queues for different access categories, maintaining service requirement within these queues; which imply that frames from a higher priority queue, i.e. video frames, are serviced more frequently than those belonging to lower priority queues. Such an enhancement at the MAC sub-layer introduces uneven queuing delays. Conventional routing protocols are unaware of such MAC specific constraints and as a result, these factors are not considered which result in channel performance degradation. To meet such challenges, the thesis presents FCS and TM schemes for WiMAX. For FCS, Its solution is to improve the mobile WiMAX handover and address the scanning latency. Since minimum scanning time is the most important issue in the handover process. This handover scheme aims to utilize the channel efficiently and apply such a procedure to reduce the time it takes to scan the neighboring access stations. TM uses MAC and physical layer (PHY) specific information in the interface metric and maintains a separate path to destination by applying an alternative interface operation. Simulation tests and comparisons with existing multi-homed protocols and handover schemes demonstrate the effectiveness of incorporating the medium dependent parameters. Moreover, show that suggested schemes, have shown better performance in terms of end-to-end delay and throughput, with efficiency up to 40% in specific test scenarios.